Ready Remote 24921 Installation Guide download pdf (Page 15)

Safety Shutdown Wires

H3/3 BROWN (+) BRAKE SHUTDOWN INPUT WIRE

H3/4 GRAY (-) HOOD PIN SWITCH SHUTDOWN WIRE

With all ignition wires properly connected, ﬁnd the appropriate safety shutdown wires. These are the brake

wire and hood pin wires.

Warning! These wires are meant to protect the vehicle and anyone near

the vehicle. They MUST be connected to prevent damage to the vehicle and

possible bodily injury.

First locate the factory brake wire using your multimeter. Find the switch at the top of the metal arm coming

off the brake pedal. Use your vehicle speciﬁc wiring information to determine the color of this wire. With

the black lead of your multimeter still in the kick panel, probe the suspected wire with the red lead of your

multimeter.

With the brake pedal at reset, the multimeter should read 0 volts. While watching the multimeter, depress the

brake pedal. The multimeter should read 12 volts. Once you have located the correct brake wire, solder the

small BROWN (H3/3) wire in the 5-pin harness to it and wrap the connection with electrical tape.

Warning! Do not use the vehicle until you conﬁrm the operation of

the brake shutdown.

Installing the hood pin switch requires drilling a hole in a metal lip under the hood. Choose a location that

will allow the pin switch to be completely depressed when the hood is closed. The pin switch has a spade

connector on the bottom for the wire connection.

Always wear eye protection when drilling.

Crimp your spade connector to the hood pin wire, and run the wire into the vehicle's passenger compartment

through a factory rubber grommet , at the same time run the Tachometer Input wire [and Horn output wire

from the Optional Harness through the ﬁre wall. To connect them use the following steps.

Using a sharp, pointed object, poke a hole into the grommet (being careful not to damage any existing wires

in the grommet) and attach the wire to the object with electrical tape. Pull the wire through the grommet,

taking extra care to keep the wire away from any moving parts or anything that will generate extreme heat.

An alternative to this method would be to ﬁnd a spot on the ﬁrewall with sufﬁcient clearance on both sides

and drill an access hole through the ﬁrewall. Take note of what is directly on the other side of where you are

drilling as to not puncture brake cylinders, computers, etc. Once the wire is run into the vehicle and secured

from any moving parts, solder the wire to the GRAY wire H3/4 of the 5-pin harness and wrap the connection

with electrical tape.

Warning! The GRAY wire must be connected. do not use the vehicle

until you conﬁrm the operation of the hood pin shutdown. Improper

operation could result in serious injury or death.

H3/5 BLUE/WHITE (-) 200 mA 2ND STATUS/REAR DEFOGGER

This wire may be used to activate a bypass module in default mode, or it can activate the defogger circuit

when Feature Menu 2, option 8, is changed to an option setting.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 27 28

No comments

Ready Remote 24921 Installation Guide Page 15