Ready Remote 24921 Installation Guide download pdf (Page 19)

Remote start shutdown diagnostics

If the remote start activates but fails to stay running, the remote start module has the ability to inform you of

what may have caused the remote start failure. Before performing shutdown diagnostics it is important that

you let the remote start shut off on its own i.e. let it attempt to start 3 times then shut down, if this is not done

the unit will report the shutdown you used to shut off the remote start.

Note: Shutdown diagnostics does not report if the vehicles factory immobilizer is causing the problem.

To perform shutdown diagnostics:

1. With the ignition Off, press and hold the Control (valet switch) button.

2. Turn the ignition On and then back Off while holding the Control button.

3. Release the Control button.

4. Press and release the Control button. The LED on the control module ﬂashes to report the last shutdown

for one minute or until the ignition is turned on, as shown in the following table:

LED Flashes Shutdown Mode

1 ﬂash Runtime expired

2 ﬂashes Over-rev shutdown

3 ﬂashes Low or no RPM, low battery (voltage and virtual tach modes)

4 ﬂashes Transmitter shutdown

5 ﬂashes (-) Hood shutdown (H3/4 GRAY)

6 ﬂashes Brake (+) Shutdown (H3/3 BROWN)

7 ﬂashes Neutral safety shutdown (H3/1BLACK/WHITE)

8 ﬂashes Wait-to-start timed out

Programming system features

The System Features Learn Routine dictates how the unit operates. It is possible to access and change most of

the feature settings using the Control module (Valet Switch) button.

1. Turn the ignition on, then off.

2. Select a Feature. Press and release the Control button the number of times corresponding to the

feature you wish to change. Then press and hold one more time to select the feature. The LED ﬂashes

to indicate which feature # is selected.

3. Program the Feature. While holding the Control button, you can program the feature using the remote

control.

Pressing the button on the remote control selects the options in ascending order. The LED ﬂashes indicatiing

which option is selected.

Once a feature is programmed:

• Other features can be programmed within the same menu

• The learn routine can be exited if programming is complete

To access another feature in the same menu:

• Press and release the Control button the number of times necessary to advance from the feature you just pro-

grammed to the next one you want to program next, then press the Control button once more and hold it.

The learn routine exits if any of the following occurs:

• The ignition is turned On

• There is no activity for 30 seconds

• The Control button is pressed too many times

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 27 28

No comments

Ready Remote 24921 Installation Guide Page 19